Parameter: Time limit for auto. action when item is sent to central sorting

Data type:

Numeric (number of days)

Can be empty:

Yes

Can be set at the system level:

Yes

Can be set at the branch level:

No

Description

---

The parameter controls whether automatic error correction is carried out on items sent to central sorting from places other than a holds shelf or an item grouping .

If the parameter is not set, no error correction is run.

If the parameter is set, the value specifies the amount of time that must go by before an item, which is currently registered as en route to central sorting but has not previously been placed on a holds shelf, is error corrected.

This is calculated in whole days, measured from the time the item was registered as “sent to central sorting” until the time when the job handling the error correction is run (typically runs at night). If the parameter is set on 0, all of the relevant items are error corrected during the next run. If the parameter is set on 1, items that have been inactive for at least 1 day, etc., are error corrected.

If the item is registered in the system again before the time limit expires, the item is not error corrected.

The action carried out by the error correction is controlled by the Discard code used for autodiscarding parameter.